Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
Where to route a bed probe sensor cable on the A5?
noobmaker
Posts: 17Member
So, I'm looking to add ABL to my A5 in the near future, however, while planning, I wasn't sure on where to route the cable, because the cables that get out from the base seem to all have a convenient connector on the edge of the base itself.
How did the community approach this?
The only solution that comes to mind right now is to route it from the bottom front of the base, just behind the LCD screen, where there is a gap, but it doesn't seem like a great solution.
Comments
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!