Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
cutting cables
Matt
Posts: 314🌟 Super Member 🌟
Hi. if I cut any cables (eg. the one of the resistance cartridge) and I connect their four ends with connectors (eg 2pins crimped male/female connectors, or else better), it is feasible or do I risk that they won't work as good as before?
Post edited by Matt on
Comments
For the temperature sensor, low connection resistance is important. Crimped contacts are usually preferred over soldered ones as long as the crimp is valid. Make sure to use proper crimping tools and maybe practice before doing the crimps for the actual cable.
https://www.wago.com/de/verbindungstechnik/installationsklemmen-entdecken/221/221durchgangsverbinder
quite helpfull
No crimping no screwing.... and such just be carfull with your Left and right with some of the cabels
There are other lvever opeated ones like
https://www.ebay.de/itm/353366704755?mkevt=1&mkcid=1&mkrid=707-53477-19255-0&campid=5337997040&toolid=11000
But the wago ones are thesmales i found so far that work quite nicely
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!