Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
25mm layer shift !
FreddyGaertner
Posts: 11Member
Hi
i just checked on a 24+ hour i had going (12 pieces of the same design covering the whole bed) and the whole print (on every single piece) shifted 2 times for a total of 25mm and since i was somewhat close to the edge it started printing in midair outside the print bed area 😱
what could be the cause ? bad gcode ?
here is a picture of the layer shift
and here you can see it was printing outside of the print bed
i just checked on a 24+ hour i had going (12 pieces of the same design covering the whole bed) and the whole print (on every single piece) shifted 2 times for a total of 25mm and since i was somewhat close to the edge it started printing in midair outside the print bed area 😱
what could be the cause ? bad gcode ?
here is a picture of the layer shift
and here you can see it was printing outside of the print bed
Comments
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!