Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
First upgrades needed for the printer
sanjibukai
Posts: 34🌟 Super Member 🌟
Hello everybody,
I'm used to use two 3d printers (i3 clone and kossel) that needs a lot of tweaks and upgrades from the beginning..
Can anyone list what the possible upgrades we can bring to the A5?
Even a wiki will be great!
So far here are the things I read:
I'm used to use two 3d printers (i3 clone and kossel) that needs a lot of tweaks and upgrades from the beginning..
Can anyone list what the possible upgrades we can bring to the A5?
Even a wiki will be great!
So far here are the things I read:
- Reduce (or even disable when cold) the hotend fan that is EXTREMLY annoying
> As I understood, this needs some electronics and firmware changes, right?
> Another option could be to add the possibility to switch off the power part of the PSU altogether - Changing to Trinamic drivers
> Great videos from DaHai: - Adding Octopi setup
> Great video from DaHai: - Adding bltouch (not sure if really needed)
- Improve (or add a cable guide) to the X stepper motor cable
- Improve the bowden tube position (maybe by hangging it towards the upper center of the arch
Comments
Yeah I noticed that there are many great resources!
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!