No Filament out detection on TFT-Display Ver. 3.0.2 (2018/05/05) ?

AETEK

Hello,

Unfortunately, my A5 Touch Display MKS TFT28 with firmware ver. 3.0.2 (2018/05/05) does not recognize when the filament is off. Does this work for you (with the same firmware version)?

I have measured the signal and it is on the display connector. It is therefore not a hardware problem. It works with the January version. This one has bad bugs.

Samuel Pinches

Can you please try this one: https://www.dropbox.com/s/6wjjd2a7n5ue9yq/JGAurora A5 Custom LCD firmware - 030718 Version B.zip?dl=0

Samuel Pinches

Is that the version you are using?

AETEK

Hi,

 My version is Ver. 3.0.2

This is the latest on Github.

I will try it....

AETEK

I'll go crazy. If I'm not mistaken, I've tested this version before (then called by you beta).

Then I added the power off button.

So with your version, the filament out detection works.
With my variant (with the power off button) not.
I have to compare the config files.
Maybe I made something worse.
Thank you. Now I have an approach to error search.

AETEK

It works again. I probably changed a parameter that I should not have changed.

Samuel Pinches

Check the last 5 options in the config, near the end of the files - I have a suspicion the problem could be there. 

AETEK

#shield the function of detection filament (0:no shield ,1:shield)

I did not understand what the Chinese wanted to tell us.

Samuel Pinches

You could say the knowledge was shielded from us!   

I think it means “ignore sensor value and disable” those functions.