Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
PROBLEMAS CON LA IMPRESION. | Problem with print shifted to the corner
jonaneriz
Posts: 1Member
Buenos días,
Tengo una JG AURORA A3S desde ayer. La he calibrado, y todo ok. El HOME esta en una esquina delantera izquierda.
A la hora de imprimir, en Cura pongo el modelo en mitad de la mesa, aparentemente, pero cuando meto el pen-drive para imprimir, me empieza a imprimir en la equina del HOME, en vez de en el centro de la mesa.
No se que estoy haciendo mal.
Alguien me puede ayudar?
Muchisimas gracias.
Tengo una JG AURORA A3S desde ayer. La he calibrado, y todo ok. El HOME esta en una esquina delantera izquierda.
A la hora de imprimir, en Cura pongo el modelo en mitad de la mesa, aparentemente, pero cuando meto el pen-drive para imprimir, me empieza a imprimir en la equina del HOME, en vez de en el centro de la mesa.
No se que estoy haciendo mal.
Alguien me puede ayudar?
Muchisimas gracias.
=============
Good Morning,
I have a JG AURORA A3S since yesterday. I calibrated it, and everything ok. The HOME is in a left front corner.
At the time of printing, in Cura I put the model in the middle of the table, apparently, but when I put the pen-drive to print, I began to print on the equine of the HOME, instead of in the center of the table.
I do not know what I'm doing wrong.
Can somebody help me?
Many thanks.
Post edited by Samuel Pinches on
Comments
This is a common problem, the answer is on the A5 / A3S frequently asked question (FAQ) page here.
That should solve your problem. Please let us know how you go.
Best regards,
Sam
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!