Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
mesh bed leveling gcode problem A5
bernd1000
Posts: 4Member
After updating to 1.1.8C and last LCD Firmware iam able to store the meshleveling points.
i use SFY3D and iam getting an error right after printstart that the meshlevelling couldnt be initiated.
I use M420 S1 just behind G28 in starting script. Is that the wrong place for this gcode??? i say thank you in advance.
Bernd
i use SFY3D and iam getting an error right after printstart that the meshlevelling couldnt be initiated.
I use M420 S1 just behind G28 in starting script. Is that the wrong place for this gcode??? i say thank you in advance.
Bernd
Post edited by bernd1000 on
Comments
Whats the output?
Did you reset the eprom after upgrading (M502 M500)?
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!