Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
Auto bed leveling
demillertime
Posts: 35๐ Super Member ๐
I just completed the auto bed leveling mod and everything went pretty straight forward. Not too difficult. I tried running it though and my extruded is extruding quite a distance away from the bed. Do I just need to adjust my z start down closer? Or is there something else going wrong here?
https://youtu.be/s0J1Xhn0AHs
https://youtu.be/s0J1Xhn0AHs
Comments
https://www.matterhackers.com/store/l/olsson-ruby-nozzle-175-x-040/sk/M9EQEEFM?rcode=GAT9HR&gclid=EAIaIQobChMI3t-g0p6V2gIVAobICh0FrwS_EAQYASABEgIx9_D_BwE
https://www.antclabs.com/bltouch
I have not tried it... I think there are two wires as a z endstop switch, and three wires for the servo connection.
servo connection on the MKS Gen l is on the bottom right.
You'll need a mount. If you don't mind losing the front panel, I went with this one for 0 offset in the X direction:
https://www.thingiverse.com/thing:2831498
The wires that come with the sensor are going to be too short. You'll either have to create an extension or buy one.
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!