Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
"#power down" and too much"LCD ID:9341"
sametarayici
Posts: 4Member
Hi
Have a nice day!
I have jgaurora a5s 3d printer
The touch screen turns itself off randomly during printing and then turns on again
I observed with pronterface. I found the following errors
It gives LCD ID error continiously and LCD Screen is twinkling at the same time.
How can I solve this problem? Thanks!
It gives LCD ID error continiously and LCD Screen is twinkling at the same time.
How can I solve this problem? Thanks!
Comments
Jgaurora will send new motherboard
I resaeting LCD connector and but the problem continues
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!