Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
A5 bed heater cycling
Godzilla32
Posts: 10Member
Hey guys. I'm having an ongoing issue with the bed heater cycling on and off. When it cycles on the clearance between the nozzle and bed gets considerably tighter and then looser when its off and slightly cools. If i have a feeler gauge or the plastic sheet etc between the nozzle and bed it gets quite tight when the heater is on and then basically loose when its off. Its possible to see the distance change in the first layer if i print a wide solid first layer. Ive tried mesh bed leveling but thats when i noticed the issue while i was setting up the clearance. Any help would be greatly appreciated.
Comments
greetings Godzilla32,
is there any update?
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!