Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
Filament loading
Spark
Posts: 49🌟 Super Member 🌟
All my other printers load filament from the top down. Is there a way to change this printer to load the filament from the top down? That way I can use the system I already have a setup where I have a bunch of rolls of filament on a rod above the printer and then just choose a color. Right now I have to take the roll off the bar to use it.
Comments
If it isn't that often, I would just ignore it.
If I'm not mistaken, the clicking sound is due to the nozzle being too close to previous layer. So, the extruder motor faces some difficulty to extrude the filament, and causing itself to rotate backward (thus the clicking sound) a bit.
What I did was trying to reduce flow rate or increase layer height.
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!