Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
Bed leveling problem - diagonal corners
kbi
Posts: 1Member
Hello! Yesterday i received my first 3d printer - JGAurora A1. Build quality feels great and assembling was simple. However i still cant get it to print good 1st layer... Leveling the bed feels impossible. Lets say my build plate is like this, where each letter represent each corner:
A---B
C---D
So when im leveling it step by step, starting by screwing each corner screw to the max, then leveling by going from corners C > D > B > A > the middle (like the guide says) im ending up adjusting every corner, and on the second 'lap' every corner besides the one that was just adjusted ends up beign deleveled. After few more laps im ending with corners A and D screwed to the max, and corners B and C unscrewed completely and the bed is still not leveled...
Any tips?
Comments
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!