Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
Falshing firmware via st-link
taxidude
Posts: 3Member
hi,
i have a little problem with my A5S, if i switch the printer on i only get a white screen, so i read in forum that this is a firmware issue, packed frimware on sd pluged in printer and switched on waited 30 second and switched of, the without sd card on again and, still white.
so i opend the device, and connected the st-link , if i start stm32 and press connect the device is not found. the 2 green led on mainboard are on.
are there any settings to adjust in the stm32 software??
and for what are the 2 micro buttons on the board??
thank you
i have a little problem with my A5S, if i switch the printer on i only get a white screen, so i read in forum that this is a firmware issue, packed frimware on sd pluged in printer and switched on waited 30 second and switched of, the without sd card on again and, still white.
so i opend the device, and connected the st-link , if i start stm32 and press connect the device is not found. the 2 green led on mainboard are on.
are there any settings to adjust in the stm32 software??
and for what are the 2 micro buttons on the board??
thank you
Comments
i connected swdio and swclk and ground on the board connector with the corrospondig pins on the st-link, but no connection.
are there any settings to be made in the st-link programm under target.?
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!