Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
Firmware upload loop
eyes
Posts: 70π Super Member π
I am trying to upload changes to my modified custom community firmware. I have never had any problems before. I have even tried with the official firmware. I am getting Dowload FW success. Then Fat Mount OK over and over again. It is the same no matter what version I tried. My printer is at work and when I came in today I could tell from the computers that the power went out last night.
Could my board be damaged?
Could my board be damaged?
Post edited by eyes on
Comments
https://jgmakerforum.com/discussion/730/how-to-compile-your-own-custom-marlin-2-0-firmware-for-jgaurora-a5s-and-a1/p1
>Fat mount fail
>execute firmware...
Any other ideas?
I am going to try a full chip erase. It can't hurt.
Β If you can rebuild a new firmware yourself, there will be two files produced, a file with the bootloader and a file without the boot loader. Then you should be able to flash the file with the boot loader using the ST link, and have that work.
please see the wiki for the links about how to get started and compile your own firmware.
you cannot upload the SD card firmware over ST link because it does not have the boot loader.
I have an skr v1.3 board I was using for bltouch support before frezap posted his instructions for using the stock board. If it's my board then I'll just change back to the skr board. I just couldn't use the stock lcd with it so I'dΒ have to replace that.Β
Thanks again for your help!
Trying my version with a new and formatted SD card uploads to 100% then stops and does not go any further.Β
>fat mount ok
>download fw
file : xxx bytes
>download FW sucess
>enter FW...
Status: bar is at 100%
I am totally lost now. Stock firmware still works so I don't think they would replace my board.
I guess my printer is going to get the SKR v1.3 board!
I can probably provide a 2.0D build with bootloader if needed.
I won't be near my printer again until work next Monday. If I upload my files can you try compiling on your end and uploading the files? I even tried changing to atom today instead of Visual Studio code. I am linking a zip of my entire directory so I don't miss any files. I you have to do do it I would appreciate it.Β
I have given up getting my boardΒ revived and switching over to the SKR v1.3 board. That combined with drylin bearings should make it much quieter.Β
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!