Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
Official Firmware
Hevilp
Posts: 136π Super Member π
Hi,
I don't know if you recognized it, but here
http://www.jgaurora3d.com/list_21.aspx
is the official firmware to download
I don't know if you recognized it, but here
http://www.jgaurora3d.com/list_21.aspx
is the official firmware to download
Comments
it was very good to see JGAurora provide the source code for their A5 and A3S printers.
My questions are:
1) is there necessary or compulsory to flash Marlin 1.1.8? Because the official firmware is based off Marlin 1.1.6, not much difference between them I guess since their versions are quite close?
2) The process of flashing new firmware requires to move and turn the printer around to unplug the LCD cable, so every time and next time after flashing new marlin firmware, I will need to calibrate bed leveling again?Β
2) I usually just hang 2 inches of the front of the printer off a table edge. There is a hole in the bottom of the printer near the front that allows just enough clearance to unplug the LCD cable. Major movement of the printer might required a new bed levelling, but I can't say yes or no for certain.
The difference between community is the Configuration.h, Configuration_adv.h and pin_RAMPS.h or is there something more
Which is it?
@Samuel Pinches
Can you please split up the sidetalk about my stepper driver problem and merge into the right thread? That would be nice.
Here is the link of it:
Marlin 2.x.x Github-release 07.06.2018
https://www.amazon.de/clouddrive/share/msAy6maCifvW5LfI6VbS1Zrm7dhz9JkbnBYJ2zm224j
You need Arduino 1.9 (it is a beta).
It is untested, I have my own version with TMC2130 which is running flawless. Please post errors here, maybe I forgot to change 1 line, I don't remember ^^
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!