Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
TFT28 V4 vs V3 firmware issues
Hi, My latest delivered A5 comes with version 4 of the TFT. However, with the same upgraded firmware to have mesh leveling, etc... All seems to work OK, except when the filament detection was activated. The result : you are aware the filament went out (end of the roll) and the classic long beep; then the printer goes to wait position (normal) but on LCD, when you access to change filament, even if you have the right screen, Nothing happens when you press OUT to replace the filament. All other functions seems to be OK on LCD. But the only alternative you have is to cancel the printing job and loose the piece. Happened to me several times. With V3 on my other printer, all is fine. I think a specific new firmware for V4 TFT is now necessary. Some one notified that as me ?
Thanked by 1Samuel Pinches
Post edited by Enrique Riri on
Comments
New features with version 3.03:
V3.03
1.the content of V3.0.3 firmware modification(2018/10/23)
as i can see that there are many changes and fixes in v3.03 firmware, i'd like to flash it in my A3S printer replacing just the bin file like Enrique Riri did.
Do you think is it safe enough? or there will be board compatiblity problems?
I'm also looking at the config file and it's pretty much the same.
The icons in the original firmware are the Win8 styled ones.
I will try to flash it tonight.
tnx
V3.0.2 firmware modification(2018/05/05):
(1).Add the "M-off" button to the "Home" interface
(2).We changed default temperature 180 to 0 in the "Preheat" interface
(3).Add the function of display mainboard eeror
(4).in the fan inerface,press the "+" or "-",the fan work
(5).fixed the bug of click "more" restart
(6).The board will stop operating more than 5 times when using the M110 re-instruction command
(7).Increase the configuration item to shield power failure detection function
(8).Modify the bug that serial port interrupt sending will be interrupted
(9).Modify the bug of read failure in U disk or SD card printing
(10).Increase configuration items to support dual extruder single nozzle.
(11).Add a button in the WIFI interface to control wifi module function open or close
(12).Fixed bug that the simple version and the retro version manual leveling wasn't go home
(13).Wifi firmware was fixed bug that function incorrect when password less than 8 digits
V3.0.3 firmware modification(2018/10/23)
(1).Bootloader display can be rotated 180°.
(2).Add configuration items to block error reporting.
(3).Manually add temperature function when power failure is not saved to the extrusion head temperature.
(4).Add configuration item:the length and speed of Load filament before unloader filament.
(5).Add a prompt box when the material is paused at the beginning of printing.
(6).Fix bug: When the break detection is configured as a high level trigger, no loading can resume printing.
(7).Add configuration item: You can choose whether to configure the M110 command for different Marlin versions.
(8).Fix bug of print stop.
(9).Adjust the position of the Z axis before X and Y move when manually leveling.
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!