Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
Many Problems with the A5
jirgel
Posts: 30Member
Hello my name is Jörg and i have many Problems with the a5.
First sorry for my bad english.
My A5 stops in the middle of the print.
Or he dont head up the bed or the nozzle or stops in by 50 c.
But the good news sometimes have my a5 a good day and prints.....
I have it 3 weeks and my nervs a down.
I have flash the firmeware of lcd and board by the videos of Samuel and dahaizu but the a5 do it again. I read the wiki but i find nothing what is wrong with my a5 must i buy a new makerboard?
Please help i can read english but im not a good writing
First sorry for my bad english.
My A5 stops in the middle of the print.
Or he dont head up the bed or the nozzle or stops in by 50 c.
But the good news sometimes have my a5 a good day and prints.....
I have it 3 weeks and my nervs a down.
I have flash the firmeware of lcd and board by the videos of Samuel and dahaizu but the a5 do it again. I read the wiki but i find nothing what is wrong with my a5 must i buy a new makerboard?
Please help i can read english but im not a good writing
Post edited by jirgel on
Comments
Welcome to the forum!
Sorry to hear of your issues. I suggest putting the main motherboard into full debug mode: send the command "M111 S1" - that way more info will be sent as you print. You will need to resend this code whenever the main motherboard is reset.
In my experience, this is typically caused by a faulty USB stick, poor USB stick connection, or a faulty front LCD module.
The USB sticks are ok.
So it is mks tft. I will it open to day maybe i have broke something when i flash to the forums firmware.
If a buy a new one what must i do for flashing?
Thank you for your help.
I suggest try turning on debug mode with command: M111 S1
Please activate a material from the material manager. Or message me privately and I can help via teamviewer.
This thing steal my sleepingtime every day😂
Or my machine gremlin hate me.....
Thank you and the forum for the Help😉
The heatbed dont stop heating!
But the heatsensor shows the right temp is the bed non aktivatet. Wenn i put a hot cup if tee on the middle of the bed he show it normaly.
But when i start to print the heatbed dont stops heating on the right temp he shows 49 or 50 c and the bed have real 90c or more.
Sam i am a noob on this and i am scare to burn down my house where we beginn ? Pls say yow where we beginn.
Error:Heating failed, system stopped! Heater_ID: bed
[ERROR] Error:Heating failed, system stopped! Heater_ID: bed
Error:Printer halted. kill() called!
[ERROR] Error:Printer halted. kill() called!
and my last question what for a termistor is in the middle of the bed soldered maybe i soldered a new one.
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!