Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
TCM2XXX why should I need Firmware 1.1.9C?
Prokktor
Posts: 146🌟 Super Member 🌟
Hi,
in the Wiki there are 2 text guides linked onhow to install TCM2XXX stepper drivers, both state I need 1.1.9C Firmware for these specific guides.
Other Guides (in this Forum and Da Hais Video) do not talk about 1.1.9C and I cant find any difference between all the guides except Da Hai connects the CS pins differently, but he can change the pins in 1.1.8C so that cant be it...
So what am I doing wrong when following those guides while using 1.1.8C?
Regards,
Martin
in the Wiki there are 2 text guides linked onhow to install TCM2XXX stepper drivers, both state I need 1.1.9C Firmware for these specific guides.
Other Guides (in this Forum and Da Hais Video) do not talk about 1.1.9C and I cant find any difference between all the guides except Da Hai connects the CS pins differently, but he can change the pins in 1.1.8C so that cant be it...
So what am I doing wrong when following those guides while using 1.1.8C?
Regards,
Martin
Comments
Its not for the noise alone:
The original drivers have microstepping problems that are normally solved with TL SMOOTHERS, I think I read that TCM dont have those problems because of the 256 interpolated microstepping. So I will do Z too, but extruder is probably not necessary.
I have around an hour per day for my printer, I am still at cable management^^
Also my X current wont help you because I have a direct drive system now.
Try the valves X800 Y500 Z900 E450 Keeps every motor in a normal warm level.
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!