Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
Filament detection issues
resanchez0911
Posts: 2Member
My prints keep stopping. Printer beeps and LCD says the filament ran out but there is still plenty left. I extrude a bit and resume printing for it to do it again 5 minutes later. I tried looking for the wiring pin issue that is posted about the A5 but I can’t find that in the A5s. What should I check now?
Comments
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!