Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
Still troubles with z-axis
Matt
Posts: 314π Super Member π
I received the new stepper, and it is surely a good one: indeed I guess that the problem is in the commands of the z-axis, or even the stepper drivers (of the z-axis steppers?). But nobody's able to tell me what's the culprit!
The move commands for x and y axes go good: but when I try to move up or down the z-axis, it goes randomly up or down independently from which button I push! When I try to set all axes at home, the others set well, whilst the z-one goes nut: the steppers vibrate and stop to do it only if I push the stopper!
Today JG sent me a "firmware" (perhaps the original one) and washed their hands, but nothing happens when I try to flash it using for their video
Same when I tried to update the firmware of the lcd, using for the tutorial found in the wiki of this site. Tried also a Cura flashing with the guidelines of the tutes of Sam, but same results: didn't tried with custom firmware for fear to destroy all, and also 'cause I don't own the device that serve to do this task (unless they were palliative).
I'm afraid I'm again in the situation when I encountered the prime issues with this damn printer which nobody can adjust! And as the previous times, I have a wish to drop it from the balcony and buy something less pretending as for the outside, but at least covered by forum/helpdesk and without all these damn issues!Post edited by Matt on
Comments
You can flash firmware on any stock MKS gen L board, just follow my guide for A5 on the wiki.
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!