Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.

Back to Profile

itisnot_me

Good to know that it was a mechanical problem. I always thought it was a problem with the printer

Also after digging deep (and learning not to be lazy) into my newer printers (not JGA ones) I…

Thanked by 1Samuel Pinches
Disconnect the LCD when upgrading?

Thanked by 1coolt5
That was before the change of the new couplers. The new couplers took out some of the large stuff. Like a lot. Even taking out the wobble that you are talking about. This is the back of the towers, b…

Thanked by 1Samuel Pinches
I do no have a way to cut the prints to check the cross section.

Per all the rest of the prints the wobble is pretty consistent/baked not really random.

<img src="https://jgmakerfo…

Thanked by 1Samuel Pinches
@Gandy I am very sorry but I was never notified you tagged me I have since subscribed to this thread.

Firstly here is the most updated profile I use. It has been tested on other printers with…

Thanked by 2Gandy Samuel Pinches
The only thing you can possibly do to help is actually calibrate the extruder steps. Assuming you have at least 1.1.8 community firmware installed.

I decided to actually do it I noticed my a…

Thanked by 1Gandy
@beata I found that the 1/2" nylon spacers from Lowe's worked but you either need a bltouch (or some bed leveler) or you need to modify the z endstop switch lower to account for the height difference…

Thanked by 1beata
update. https://github.com/MarlinFirmware/Marlin/issues/8302#issuecomment-345091390

comment out the LCD_BED_LEVELING to get rid of that error. Verifies. Lets hope for the best

Thanked by 1Samuel Pinches
sorry i am not any help but some people have lots of thoughts. https://www.reddit.com/r/3Dprinting/comments/42i5rz/why_are_there_waves_in_my_first_layer/

sum up.
over extrusion
too ho…

Thanked by 2JayJoe Samuel Pinches
Questions:

After the last level did you type G29 S2, then when its done moving type M500?

Secondly have you added <span>M420 S1 after G28 command within your GCode slicer? Not t…

Thanked by 1Samuel Pinches
In a way it might sound like you have a slightly warped bed. I know you said that you didnt want to modify the firmware but i feel that it is super important to do so as it would give you mesh leveli…

Thanked by 1Samuel Pinches
For the attached file. Default settings on cura. I believe .3mm stock settings, besides maybe 200 nozzle and 60 bed. The only thing different from the side by sides is the firmware. Cura never did cl…

Thanked by 1Samuel Pinches