Getting Started & Troubleshooting

Discussion List

• A3S resetting when heating up bed and extruder..

  78 views 4 comments 0 points Most recent by Stephen Todd March 2020Getting Started & Troubleshooting
• Slow to start printing

  121 views 21 comments 0 points Most recent by Stephen Todd April 2020Getting Started & Troubleshooting
• Power Supply Unit outputting 29V

  40 views 4 comments 0 points Most recent by bukl April 2020Getting Started & Troubleshooting
• Stepper motors wont move, need help diagnosing issue

  78 views 1 comment 0 points Most recent by Stephen Todd March 2020Getting Started & Troubleshooting
• optimal settings for printing tpu

  214 views 4 comments 0 points Most recent by Samuel Pinches March 2020Getting Started & Troubleshooting
• MKS GEN-L V1.0 VS MKS SGEN-L V1.0 Exchange

  1.4K views 2 comments 0 points Most recent by Oli61 March 2020Getting Started & Troubleshooting
• Print breaking

  94 views 8 comments 0 points Most recent by Samuel Pinches March 2020Getting Started & Troubleshooting
• A3S: things getting worse, bad temperature readings, no moves

  36 views 2 comments 0 points Most recent by Stephen Todd March 2020Getting Started & Troubleshooting
• Very loud bed (Y-axis) noise on my A3S

  56 views 5 comments 0 points Most recent by Stephen Todd March 2020Getting Started & Troubleshooting
• Temperature always 96 celsius

  32 views 1 comment 0 points Most recent by Samuel Pinches March 2020Getting Started & Troubleshooting
• Jgaurora A5 hotenheating stops at 130 degrees

  136 views 11 comments 0 points Most recent by Mathieu Grumplefix Evain May 2020Getting Started & Troubleshooting